Hello my beautiful Hive Family, greetings and blessings to all. Today I want to show you a fantastic idea, it's a pincer made with the rings of soda cans. I loved to make it, it's amazing how we can make countless ideas, with only materials that we can find in our home, now yes, join me to see this sensational creation.
Below is the procedure for this great idea:
Materiales:
- Cintas del color de su preferencia, 30cm de cada color.
- Silicón.
- Tijera.
- Pinza para el cabello, para colocarlo en nuestra pinza.
- Las anillas de las latas de refresco.
Materials:
- Ribbons of the color of your choice, 30cm of each color.
- Silicone.
- Scissors.
- Hair clip, to place it in our hair clip.
- The rings of the soda cans.
1- Pegamos extremo con extremo, las puntas de nuestra cinta.
2- Luego pasamos la cinta por el orificio de la anilla de la lata de refresco, hasta llegar a la unión de ambas puntas de la cinta.
1- Glue the ends of our ribbon end to end.
2- Then we pass the ribbon through the hole in the ring of the soda can, until we reach the junction of both ends of the ribbon.
3- Procedemos a pasar cada unas de las anillas de la lata de refresco. Hasta quedar de esta manera.
3- We proceed to pass each of the rings of the soda can. Until it looks like this.
4- Pegamos con silicón cada una de las anillas de las latas de refresco, solo un pequeño punto de silicón en la parte inferior, en la esquina.
5- Luego cortamos el excedente de la cinta restante.
4- Glue each of the soda can rings with silicone, just a small dot of silicone at the bottom, in the corner.
5- Then cut off the excess of the remaining ribbon.
6- Volteamos la pinza, y pegamos el excedente que quedó de la cinta.
6- Turn the clamp over and glue the excess tape.
7- Pegamos la pinza a nuestra creación.
8- Procedemos a cortar la mitad de nuestra cinta, para resaltar la delicadeza de nuestra pinza.
7- We glue the clip to our creation.
8- We proceed to cut half of our ribbon, to highlight the delicacy of our clip.
Este es nuestro resultado final, fue un gusto poder realizar esta linda pinza, siempre me han gustado mucho las anillas de las latas de refrescos, y plasmarlas en esta Linda Pinza, fue muy importante para mi, saludos y bendiciones mi linda familia de Hive.
This is our final result, it was a pleasure to be able to make this nice clamp, I have always liked the soda can rings, and to capture them in this nice clamp, was very important to me, greetings and blessings my beautiful Hive family.
All photos are my authorship.
Congratulations @eribetzi! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :
Your next target is to reach 2250 upvotes.
You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word
STOP
Check out the last post from @hivebuzz:
Support the HiveBuzz project. Vote for our proposal!