Table and chairs renovation

in Build-It3 years ago

Today I am going to present to you the renovation of the old table and chairs I've made some time ago.

WhatsApp Image 2021-09-21 at 12.03.47 AM.jpeg

table and the chairs - final effect

IMG_20191213_180446542.jpg
table and the chairs before

The table and the chairs were going to be thrown away by the previous owner of the apartment but when we moved in, I asked her to leave it and decided to renovate it a bit.

Chairs were with the black metal part but because it was old, some places were without the paint anymore. Chair cushions were in disgusting, brown color (I'm not sure if it was the original color or just the dirt). It was with the big holes. Sponges inside were basically smashed so much that sitting on them was like sitting on the desk. It was molded too.

IMG-20200729-WA0004.jpg
this is how chair looks after the renovation

IMG-20200722-WA0010.jpeg
and this is one of the chair cushions before I've changed it. This one had additional iron burn

The table had black legs and a black side part of the tabletop. In some places, the paint was removed though so you could see the wood of the tabletop and metal of the legs.
The top was with some white lacquer but with several scratches and holes. There were also two spots with burned circles, probably caused by putting the hot pot directly on the table.

IMG-20200722-WA0006.jpeg
Table after painting it

IMG-20200725-WA0001.jpg
on this photo you can see that it's now more stone-like

WhatsApp Image 2019-12-23 at 14.50.18 (1).jpeg
table before painting with some damages

I painted the chairs and table with black paint for metal. To paint the top, first I scratched the old lacquer, then painted it with three layers of the paint and in the end, I used special lacquer to make sure that paint will last for longer. The final effect made the table look like it's made of stone - it has characteristic roughness caused by the paint I used.

IMG-20200722-WA0000.jpeg
painting the chairs and the table in black

IMG-20200722-WA0004.jpeg
I didn't care about the floor as I knew I will be changing it right after

I removed old sponge and cushions from the chairs. I bought a new sponge, cut it, and glued it to the desks. Then I sized and cut the fabric which I bought and attached it to the desk with the tucker.

IMG-20200729-WA0002.jpg
measuring the fabric

IMG-20200729-WA0003.jpg

IMG-20200729-WA0005.jpg
using the tucker to connect the fabric to the desk with glued new sponge

Finally, I glued small sponges to the legs of the chair to avoid damaging the floor when using it.

All the transformation took me three days (mostly because I had to wait for the paint to dry between putting other layers). The total cost was lower than the cost of buying one new chair in the shop.


All the photos included in the post belong to me.
Thank you for reading,
@papi.mati

Sort:  

Congratulations @papi.mati! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :

You received more than 3000 upvotes.
Your next target is to reach 3250 upvotes.

You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word STOP

Check out the last post from @hivebuzz:

Hive Power Up Month - Feedback from Day 20